Shaft,SS,0.750 In D,24.00 In

Technical Specification Item Stainless Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 24 Travel Length (In.) 24 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Mounting Surface to Shaft Center (In.) : - Travel Length (mm) : - Base Height (In.) : - Mounting Hole from Shaft End : - Thread Length (In.) : 0.625 in Material : Stainless Steel Base Height (mm) : - Dimension C : - Base Width (mm) : - Dimension G : - Mounting Hole Center to Center : - Dia. Tolerance Max. : 0.7492 in Travel Length (In.) : 24 in Thread Length (mm) : - Mounting End Dia. (In.) : 0.75 in Mounting Holes : - Agency Compliance : - Dimension X : - Min. Surface Hardness : 56 HRC Dimension Y : - Dia. Tolerance Min. : 0.7497 in Mounting Hole Size : - Type : - Dimension E : - Overall Height (mm) : - Dimension B : 0.625 in Item : Stainless Steel Shaft Shaft Dia. : 0.75 in Dimension F : - Dimension M : 5/16-18 For Use With : - Dimension L : 24.0 Includes : - Temp. Range (F) : 284 F Overall Height (In.) : - Length : 24 in Thread Size : 5/16-18 Bolt Size : - Finish : - Mounting End Dia. (mm) : - Dimension P : - Mounting Hole Center to Center (In/mm) : Dimension L1 : Dimension L2 : Dimension H4 : Carriage Hole Size (mm) : Rail Height : Dimension H : Base Width (In.) : Dynamic Load Capacity (N) : Dimension S X l (Carriage Hole Size) : Liner : Carriage Material : Carriage Height : Number of Rail Holes : Mounting Hole to End (In/mm) : Max. Pv : Seals : Dimension D3 : Running Clearance (In/mm) : Dimension W : Rail Length : Carriage Hole Size (In.) : Max. Speed (m/Sec) : Dimension N : Dimension W4 : Base Width : Static Load Capacity (Lb.) : Rail Material : Carriage Length : Dimension W3 : Rail Width (mm) : Static Load Capacity (N) : Dimension H1 : Carriage Type : Dynamic Load Capacity (Lb.) : Dimension D2 : Max. Speed (In/Sec) : Rail