Shaft,SS,0.750 In D,6.00 In

Technical Specification Item Stainless Steel Shaft Shaft Dia. 0.75 Dia. Tolerance Min. 0.7497 Dia. Tolerance Max. 0.7492 Mounting End Dia. (In.) 0.75 Thread Size 5/16-18 Thread Length (In.) 0.625 Length 6 Travel Length (In.) 6 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Dimension F : - Dimension Y : - Mounting Holes : - Dia. Tolerance Min. : 0.7497 in Item : Stainless Steel Shaft Dimension M : 5/16-18 Dimension E : - Base Height (mm) : - Agency Compliance : - Dimension B : 0.625 in Temp. Range (F) : 284 F Material : Stainless Steel Thread Length (mm) : - Dimension X : - Finish : - Includes : - Thread Length (In.) : 0.625 in Dimension G : - For Use With : - Thread Size : 5/16-18 Dimension P : - Mounting Hole Center to Center : - Travel Length (mm) : - Mounting Hole Size : - Min. Surface Hardness : 56 HRC Mounting Hole from Shaft End : - Base Width (mm) : - Dia. Tolerance Max. : 0.7492 in Mounting End Dia. (In.) : 0.75 in Shaft Dia. : 0.75 in Dimension L : 6.0 Mounting Surface to Shaft Center (In.) : - Overall Height (In.) : - Base Height (In.) : - Mounting End Dia. (mm) : - Length : 6 in Bolt Size : - Travel Length (In.) : 6 in Overall Height (mm) : - Type : - Dimension C : - Dimension W2 : Carriage Type : Dimension D3 : Carriage Height : Carriage Hole Size (In.) : Dynamic Load Capacity (Lb.) : Dimension H4 : Seals : Dimension W3 : Dimension W : Rail Material : Liner : Base Width (In.) : Static Load Capacity (Lb.) : Dimension N : Dimension L3 : Carriage Material : Dimension L1 : Dimension L2 : Static Load Capacity (N) : Rail Finish : Dimension S X l (Carriage Hole Size) : Dimension H1 : Cnt Mtg Hole to Qualify Edge (In/mm) : Dynamic Load Capacity (N) : Max. Speed (In/Sec) : Rail Width (mm) : Number of Rail Holes : Running Clearance (In/mm) : Dimension W4 : Rail Height : Base Width : Carriage Width : Hole Size : Mounting Hole to End (In/mm) : Dimension H : Carriage Length : Dimension W1 : Dimension