Shaft,SS,1.000 In D,12.00 In

Technical Specification Item Stainless Steel Shaft Shaft Dia. 1 Dia. Tolerance Min. 0.9997 Dia. Tolerance Max. 0.9992 Mounting End Dia. (In.) 1 Thread Size 3/8-16 Thread Length (In.) 0.75 Length 12 Travel Length (In.) 12 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Type : - Item : Stainless Steel Shaft Thread Length (In.) : 0.75 in Thread Length (mm) : - Overall Height (In.) : - Agency Compliance : - Bolt Size : - Mounting Hole from Shaft End : - Temp. Range (F) : 284 F Min. Surface Hardness : 56 HRC Dimension L : 12.0 Mounting End Dia. (mm) : - Dimension P : - Overall Height (mm) : - Travel Length (In.) : 12 in Thread Size : 3/8-16 Mounting Holes : - Dimension C : - Dimension Y : - Base Height (In.) : - Dimension G : - Dimension X : - Mounting Surface to Shaft Center (In.) : - Material : Stainless Steel Mounting Hole Center to Center : - Length : 12 in Dimension M : 3/8-16 Dimension E : - Dimension F : - Travel Length (mm) : - Shaft Dia. : 1 in Base Height (mm) : - Mounting Hole Size : - Base Width (mm) : - For Use With : - Includes : - Finish : - Mounting End Dia. (In.) : 1 in Dimension B : 0.75 in Dia. Tolerance Max. : 0.9992 in Dia. Tolerance Min. : 0.9997 in Dimension N : Dimension L3 : Dimension W2 : Carriage Height : Rail Length : Dimension L2 : Hole Size : Dimension W : Dimension W1 : Static Load Capacity (N) : Carriage Type : Dimension D3 : Dimension W4 : Dimension H4 : Dynamic Load Capacity (N) : Max. Speed (In/Sec) : Max. Pv : Base Width : Mounting Hole to End (In/mm) : Rail Width (mm) : Running Clearance (In/mm) : Dimension H : Cnt Mtg Hole to Qualify Edge (In/mm) : Dimension S X l (Carriage Hole Size) : Base Width (In.) : Dimension L1 : Rail Height : Rail Finish : Carriage Width : Dynamic Load Capacity (Lb.) : Mounting Hole Center to Center (In/mm) : Carriage Material : Max. Speed (m/Sec) : Dimension H1 : Rail Material : Dimension D2 : Dimension W3 : Carriage Hole Size (mm) : Carriage