Grainger.com

Technical Specification Item Stainless Steel Shaft Shaft Dia. 1.5 Dia. Tolerance Min. 1.4997 Dia. Tolerance Max. 1.499 Mounting End Dia. (In.) 1.5 Thread Size 5/8-11 Thread Length (In.) 1.25 Length 12 Travel Length (In.) 12 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Finish : - Dimension X : - Dia. Tolerance Min. : 1.4997 in Shaft Dia. : 1.5 in Dimension B : 1.25 in Dia. Tolerance Max. : 1.499 in Base Width (mm) : - For Use With : - Mounting End Dia. (In.) : 1.5 in Mounting Holes : - Type : - Thread Length (mm) : - Mounting Hole from Shaft End : - Base Height (In.) : - Material : Stainless Steel Dimension Y : - Dimension E : - Overall Height (In.) : - Mounting Surface to Shaft Center (In.) : - Min. Surface Hardness : 56 HRC Mounting Hole Center to Center : - Mounting Hole Size : - Item : Stainless Steel Shaft Dimension M : 5/8-11 Dimension P : - Base Height (mm) : - Mounting End Dia. (mm) : - Length : 12 in Thread Size : 5/8-11 Dimension G : - Dimension F : - Travel Length (mm) : - Bolt Size : - Travel Length (In.) : 12 in Temp. Range (F) : 284 F Agency Compliance : - Dimension L : 12.0 Overall Height (mm) : - Includes : - Dimension C : - Thread Length (In.) : 1.25 in Dimension W4 : Rail Length : Cnt Mtg Hole to Qualify Edge (In/mm) : Base Width (In.) : Dimension H : Hole Size : Carriage Length : Max. Speed (m/Sec) : Dimension W3 : Static Load Capacity (Lb.) : Carriage Hole Size (In.) : Dimension W1 : Max. Pv : Seals : Dimension H4 : Rail Height : Number of Rail Holes : Carriage Material : Dimension W2 : Carriage Height : Max. Speed (In/Sec) : Base Width : Dynamic Load Capacity (N) : Dimension L1 : Mounting Hole Center to Center (In/mm) : Rail Material : Dimension N : Rail Width (mm) : Running Clearance (In/mm) : Dimension L2 : Carriage Hole Size (mm) : Dimension L3 : Carriage Type : Dimension W : Mounting Hole to End (In/mm) : Dimension D3 : Dynamic Load Capacity (Lb.) : Dimension D2 : Liner :