Shaft,SS,1.500 In D,6.00 In

Technical Specification Item Stainless Steel Shaft Shaft Dia. 1.5 Dia. Tolerance Min. 1.4997 Dia. Tolerance Max. 1.499 Mounting End Dia. (In.) 1.5 Thread Size 5/8-11 Thread Length (In.) 1.25 Length 6 Travel Length (In.) 6 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Includes : - Bolt Size : - Shaft Dia. : 1.5 in Dimension P : - Mounting End Dia. (In.) : 1.5 in Length : 6 in Dia. Tolerance Min. : 1.4997 in Travel Length (In.) : 6 in Dimension C : - Travel Length (mm) : - Dimension X : - For Use With : - Material : Stainless Steel Base Width (mm) : - Overall Height (In.) : - Mounting Hole Center to Center : - Dimension M : 5/8-11 Dimension L : 6.0 Mounting End Dia. (mm) : - Dimension G : - Dimension B : 1.25 in Mounting Hole Size : - Agency Compliance : - Dimension Y : - Base Height (In.) : - Mounting Surface to Shaft Center (In.) : - Min. Surface Hardness : 56 HRC Dimension E : - Thread Length (In.) : 1.25 in Type : - Item : Stainless Steel Shaft Thread Length (mm) : - Thread Size : 5/8-11 Finish : - Temp. Range (F) : 284 F Dimension F : - Base Height (mm) : - Mounting Holes : - Mounting Hole from Shaft End : - Dia. Tolerance Max. : 1.499 in Overall Height (mm) : - Dimension S X l (Carriage Hole Size) : Hole Size : Carriage Height : Dimension L1 : Dimension W2 : Dynamic Load Capacity (Lb.) : Dimension H : Running Clearance (In/mm) : Dimension W1 : Rail Height : Carriage Length : Rail Length : Dimension D3 : Dynamic Load Capacity (N) : Max. Pv : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Hole Size (mm) : Liner : Mounting Hole Center to Center (In/mm) : Max. Speed (In/Sec) : Dimension L2 : Max. Speed (m/Sec) : Base Width : Carriage Width : Dimension L3 : Rail Width (mm) : Static Load Capacity (Lb.) : Dimension W4 : Rail Material : Dimension W3 : Dimension W : Dimension D2 : Rail Finish : Dimension H4 : Static Load Capacity (N) : Carriage Type : Number of Rail Holes : Base Width (In.) : Dimension