Shaft,SS,0.500 In D,6.00 In

Technical Specification Item Stainless Steel Shaft Shaft Dia. 0.5 Dia. Tolerance Min. 0.4998 Dia. Tolerance Max. 0.4993 Mounting End Dia. (In.) 0.5 Thread Size 1/4-20 Thread Length (In.) 0.5 Length 6 Travel Length (In.) 6 Temp. Range (F) 284 F Material Stainless Steel Min. Surface Hardness 56 HRC This listing is for each. Thread Length (mm) : - Dimension L : 6.0 Dia. Tolerance Min. : 0.4998 in Mounting Surface to Shaft Center (In.) : - Mounting End Dia. (mm) : - Overall Height (mm) : - Material : Stainless Steel Mounting Hole from Shaft End : - For Use With : - Shaft Dia. : 0.5 in Dimension X : - Thread Length (In.) : 0.5 in Mounting Hole Size : - Min. Surface Hardness : 56 HRC Mounting Holes : - Travel Length (In.) : 6 in Mounting Hole Center to Center : - Dia. Tolerance Max. : 0.4993 in Dimension F : - Travel Length (mm) : - Dimension E : - Base Height (mm) : - Overall Height (In.) : - Includes : - Dimension P : - Item : Stainless Steel Shaft Length : 6 in Dimension B : 0.5 in Base Width (mm) : - Dimension Y : - Thread Size : 1/4-20 Bolt Size : - Type : - Mounting End Dia. (In.) : 0.5 in Agency Compliance : - Temp. Range (F) : 284 F Dimension C : - Base Height (In.) : - Finish : - Dimension G : - Dimension M : 1/4-20 Dimension W1 : Base Width (In.) : Carriage Length : Rail Height : Static Load Capacity (Lb.) : Seals : Rail Finish : Static Load Capacity (N) : Liner : Dimension L3 : Dimension H1 : Dimension L2 : Dimension H : Dynamic Load Capacity (N) : Mounting Hole to End (In/mm) : Hole Size : Max. Speed (m/Sec) : Base Width : Carriage Type : Rail Width (mm) : Dynamic Load Capacity (Lb.) : Rail Material : Dimension W3 : Carriage Material : Dimension D3 : Dimension S X l (Carriage Hole Size) : Dimension L1 : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Hole Size (In.) : Carriage Width : Dimension H4 : Rail Length : Dimension D2 : Carriage Hole Size (mm) : Dimension W : Dimension W4 : Dimension N : Carriage Height : Dimension W2 : Mounting Hole