NF . CD-552R3

<b>Specifications</b><br><br><b>Absolute maximum ratings</b><br>Power supply voltage : ± 18V, Signal input voltage : ± Vs, Reference signal input voltage : +5.5V, -0.5V, Logic control voltage : +5.5V, -0.5V<br><br><b>Signal system characteristics</b><br><br><b>Signal input</b><br>Input impedance : Max. 10kΩ ± 5% (@1kHz), Linear maximum input voltage : Min. ± 10V, Allowable slew rate : Max. 5V/µs<br><br><b>Phase detector</b><br>Detection method : Synchronous rectifying type by square-wave multiplication, Detection characteristics : Vout = Vin A cos φ, Vout : detection DC output, Vin : input signal (synchronization), A : gain, φphase difference between the signal system and reference signal system, Operating frequency range : 1kHz to 200kHz, Gain (φ=0) : (sine-wave) Pins 12 and 13 open, (sine-wave) short in Pins 12 and 13, selectable in the 1 to 10Vdc/Vo-p with the external resistor (pin 12 and 13), Gain accuracy : Max. ± 3%, Phase difference (signal system and reference signal system) : -0.05° (typ.)(@1kHz), -8° (typ.)(@200kHz)<br><br><b>Low-pass filter characteristics</b><br>order : 1-pole(6dB/oct), Cut-off frequency : Pins 9-10 shorted, low-pass expansion is enabled with an external resistor or capacitor<br><br><b>Detection output characteristics</b><br>Output impedance : Max. 50Ω ± 10% (@1kHz), Linear maximum input voltage : Min. ± 10V (DC, load resistance ≥2kΩ), Linear maximum input current : Min. ± 5mA(DC), Offset voltage : Max. ± 15mV, ± 5mV(typ.), Short in input, Gain 1Vdc/Vo-p, Offset voltage adjustment : Zero adjustment available with external pre-set resistors(pin14)<br>This device is compatible with Datel Product model PDJ-100A<br><br><b>Based on this product, NF will respond flexibly customers requirement</b>