Nitrous Outlet . 00-10606-00

This system comes out of the box with everything you need to spray up to 600 HP but can spray up to 700 HP with additional jetting. Nitrous Outlet is proud to introduce the 2nd generation Stinger plate for 4150 and 4500 flange carbureted style intake manifolds. The new Stinger has a larger conical cone than the previous version and is based off of the same technology as our nitrous Puck, and is capable of delivering up to 600 horsepower of fuel and nitrous. The Stinger plate has a large unique cone shaped “stinger” that protrudes from the bottom portion of the plate into the center of the intake throat. Each Stinger has 15 discharge ports for nitrous and 15 discharge ports for fuel. The 15 atomized plumes of nitrous and fuel exit from the center of the stinger into the intake plenum in a 360 degree pattern completely saturating the air intake charge as it enters the intake plenum for even distribution. This system includes everything needed to spray 50-500 HP. Package includes the "Boomerang" 2 solenoid bracket, billet aluminum Stinger Plate, main feed line, relay, harness, jetting, hardware, and wiring. The Stinger "Race" option comes with jetting for horsepower settings from 50-600 HP, and the larger, higher flowing .178 orifice “Trashcan” nitrous solenoid, and a .310 fuel solenoid capable of flowing up to 600+ HP. This system includes an anodized aluminum 2 solenoid offset "Boomerang" solenoid bracket and pre-bent hard-lines for a clean professional installation. This system is designed to work with any vehicle using a carb style 4150 flange intake manifold.