Mount (page 2 / 2)

Four 3/8"-16 tapped holes on 3.25" bolt circle
Four slots on 2-15/16" x 1-3/4" centers
Four-bolt flange, 3/8"-16 tapped holes on 2-5/16" square centers
Four-bolt magneto
Four-bolt magneto and two-bolt SAE A
Four-bolt square
Four-bolt wheel
Freestanding
Freestanding Tubs
Front
Front Block
Front Flange
Full Escutcheon
Full Mortise
Full Plate
Glass
Hinge (Pull Side)
Horizontal
Horizontal Surfaces
ISO MX0
Included
Lower
Manifold Mount
Mount
NA
NFPA MX5 / MS4
NFPA MX5/MS4
Nose
Nose and Pivot
One Piece
Overhead
Parallel Arm (Push Side)
Pivot
Polymer Base
Portable
Post Stand
Pull Side
Push
Push Side
Push or Pull Side
Rail
Rail or Flat Surface
Ratchet strap
Rear Block
Rear Flange
Reccesed or Surface Mount
Regular Arm-Pull Side
SAE A 2 bolt
SAE A 4 bolt
SL
Screw
Sectional
Self Adhesive
Self Adhesive Backing
Self adhesive backing
Side
Side Tapped/Sleeve Nut
Single hole faucet
Snap
Snaps
Stand-alone
Supplied Brackets
Surface
Surface Mount
Surface, Wall
Table
Table Clamp
Tapped End Caps
Threaded
Threaded Posts
Threaded posts
Through Hole
Tie-Rod
Tile Flange Tubs
Tile In
Top
Top Jamb (Push Side)
Two 4.4mm dia. Thru holes on 21mm x 10mm centers
Two Bolt SAE A
Two-Point Lock
Two-bolt SAE A
Two-bolt SAE A brake mount
Two-bolt SAE A mount
Two-bolt SAE A, 7/16" dia. holes on 4-3/16" B.C., 3-1/4" pilot
Universal
Upright / Column
Vertical
Wall
Wall Mount
Wall Mounted
Wall mounting bracket supplied
Wall, Ceiling, Surface
Wall-Mounted
Worksurface
wall