Foredom M.TX Hang-Up Permanent Magnet Motor with Speed Control

Here is Foredom's higher torque flex shaft model, the M.TX hang-up style motor, is teamed up with a choice of speed controls. Two Year Limited Warranty on Motor and Control. M.TX Motor Description: Series TX motors are Foredom's most powerful flex shaft machines with 1/3HP. They have permanent magnet DC motors that feature the latest in flex shaft technology. These ball bearing models utilize advanced rare earth magnets (in place of the wound fields in Foredom's universal type Series SR motors) that deliver more torque at the low end and throughout the entire speed range of 500 to 15,000 RPM. No other flex shaft gives you greater control of the cutting tool, drill, or bur under any load. It comes equipped with a motor bale for hanging, and Foredom's standard 39? Long key tip inner shaft and outer protective sheath for connecting to any of Foredom’s quick disconnect handpieces. The M.TX hang-up model is also available in prepackaged kits K.TX300, K.TX301, and K.5400. M.TX motors are available ONLY in 115 Volt. C.EMX-1 Speed Control: looks the same as Foredom's standard table top control but it has special electronics that converts AC current from an electrical outlet to DC current, the type required by Series TX motors. This control also has a different style plug that is made to fit the motor’s shielded-type plug. The C.EMX-1 is a solid state control in a plastic housing that can be positioned anywhere on a work surface. The hand dial is used to adjust and set speed. This manual style control allows you to maintain and return to a desired speed, time and again by marking the setting on the dial. The C.EMX-1 also has a replaceable fuse that protects the electronics during power surges and work overloads. 5? Long, 5-34? Wide, 2-58? High, ship wt 2 lbs./1 kg.