Earthworks . FW430/HC-TPBMP

47 foot Hypercardioid microphone boom and tripod stand in a matched pairThe FlexWand is a combination of a 30kHz High Definition Microphone and a low profile microphone stand and boom as a single unit It allows the microphone head to be positioned as high as 47 feet and as low as 10 inches from the floor or anywhere in between There are no visible wires or cables above floor level Visually it is low profile smooth sleek and clean The FlexWand is the ideal solution for applications where the utmost in sound quality and a low profile is required Now you dont have to find a mic attach the mic clip to the stand and then dress the cable around the stand Just pick up the FlexWand position it and plug the mic cable into the base Features. Uniform frequency response on or off axis. Flat from 50Hz to 20kHz within 2dB at 6 inches. Will handle up to 145dB SPL. No handling noise. Rejects RFI. Near perfect polar response and the ability to reject sounds from the rear of the microphone making it a perfect solution for choirs and vocal groups. Large flex section near the center of the stand that couples the stand and the wand. Minigooseneck between the end of the wand and the microphone head. Incredible gain before feedbackIncludes. SRW3 Foam Windscreen for FlexWands SR25. LP1530 LevelPad switchable 15 or 30db. FWTCB Tripod base for all FlexWand models. FWCIB Cast Iron base for all FlexWand models. FWEXT2 Two foot extension. FWEXT3 Three foot extensionSpecifications. Size 4 ft. Frequency Response 30Hz to 30kHz 2dB at 6 inches 15cm. Polar Pattern Cardioid or Hypercardioid. Sensitivity 10mVPa 40dBVPa. Power Requirements 48V Phantom 10mA. Max Acoustic Input 145dB SPL. Output XLR pin 2. Output Impedance 100 balanced 50 ea pin 2 3. Min Output Load 600 Ohm between pins 2 3. Positioning Range From 15 ft to 7 ft above floor level. Gooseneck Rigid center with nominal 25 to 3 flex on both ends. Dimension Stand 47 140cm Tripod base each. Weight 12 lbs