DIXON . 2720804C

Dixon 1/2" Hose ID x 1/4" Male NPTF x Push-on Hose Barb, Brass, Dryseal (128P3SO15) …

Dixon, 2720804C, 1/2in Hose ID x 1/4in-18 Male NPT x Push-On Hose Barb, Brass Construction Dryseal Installation Assembly Instructions: 1. Trim hose end with smooth square cut. 2. Lubricate either push-on fitting, hose or both. 3. Insert push-on fitting into hose until first barb is in hose. 4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap. Instructions Disassembly instructions: 1. Leaving push-on fitting in place, make a 1in cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose. 2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose. Note No hose clamps or ferrules are needed Safety notes Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only. Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap. WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling.