F128-X 8 HOLEDALL FERRULE Requires special TM128-42/TG128-42

Applications Recommended for use on most one and two wire braid reinforced hoses, fiber reinforced (braided or spiraled) with or without helical wire such as: oil and suction discharge hose, barge and dock loading and unloading hose as well as L.P. gas hose, anhydrous ammonia hose, acid chemical hose and high pressure air and water hose. Use This part must be used with a special TG128-42, TP128-42 or TM128-42 stem. Features The coupling system requires no bolts and results in a clean coupling with no protrusions. The Holedall coupling provides long-lasting efficiency and safety. How it works The hydraulic swaging of the coupling to the hose is accomplished by pushing the ferrule through a die which reduces the ferrule OD, thus providing a 360 degree uninterrupted compression band around the hose. A hydraulic ram is the only piece of machinery necessary to accomplish the coupling. Rams are available in five different sizes- 15,25, 50,100 and 350 ton - these rams will accommodate dies and pushers of various sizes so that hoses up to 10" in diameter may be coupled. Ferrules can be swaged or crimped. Note The selection of ferrules is very important to achieve proper coupling-to-hose assembly Safety notes Dixon Holedall stems and ferrules are specifically designed to be used together as a coupling system. Due to differences in dimensions and tolerances, for safety reasons, do not use other manufacturer's stems or ferrules with Dixon Holedall products. The selection of ferrules is very important to achieve the proper coupling-to-hose assembly. Do not use a wrench or vice on ferrule Holedall couplings, regardless of coupling style, are never to be used for steam service at any pressure. Holedall fittings are not to be used with cable reinforced high-pressure hose, 4 or 6 braid wire hydraulic hose or any other service not listed in the recommendations.

Dixon 8" HOLEDALL FERRULE Requires special TM128-42/TG128-42 (F128-X)