Whether you are looking for a CNC capable unit for hobby use or for a business, the Everlast PowerPlasma 60C is specifically designed to handle the constant cutting environment of plasma tables. The PowerPlasma 60C operates on single phase 240-Volt power so it can be used in facilities without commercial 3-phase. The high voltage, inductor start feature of the PowerPlasma 60C starts the arc more quickly and pierces faster than most blow back designs on the market. The HV start improves cutting efficiency by reducing programmed delay times for piercing. It also produces considerably less EMF interference than High Frequency plasma cutters that often disrupt the electronics of the CNC system. The low dross, quality cut that produced is competitive with other brands when programmed correctly. The unit is ideal for daily cutting up to 1/2 in. plate steel at CNC production speeds up to 30-36 IPM. Ultimate severance capability tops out at 1-1/8 in. at 3-5 IPM. A clean cut capability of around 7/8 in. at 10-12 IPM can also be achieved if needed. The PowerPlasma 60C comes ready to go with a genuine Trafimet A-81 machine torch and CNC socket installed with arc voltage divider signal for torch height control operation (THC not included), and ok-to-move signals.

Whether you are looking for a CNC capable unit for hobby use or for a business, the Everlast PowerPlasma 60C is specifically designed to handle the constant cutting environment of plasma tables. The PowerPlasma 60C operates on single phase 240-Volt power so it can be used in facilities without commercial 3-phase. The high voltage, inductor start feature of the PowerPlasma 60C starts the arc more quickly and pierces faster than most blow back designs on the market. The HV start improves cutting efficiency by reducing programmed delay times for piercing. It also produces considerably less EMF in