Attributes . 0.10 . Names

1.47'' (3)   2-1/2" (3)   2-5/8 (3)   2-7/8" (3)   Accuracy (6)   Accuracy In % Of Nomina. (8)   Amps Range (4)   Blade Thickness (10)   Carton Volume (1)   Clamping Capacity (4)   Coefficient of Volume (2)   Component WR2 (lbs ft2) (2)   corner chamfer width mm (3)   corner radius mm (1)   Cv (4)   Depth (9)   Depth in Inches (1)   Dial Reading (17)   Estimated Weight (4)   Extension Cord Length (. (1)   Fluid orifice size (cm) (9)   Free Air CFM @ 20 In. Hg (1)   Frequency Measurement A. (4)   GPM (2)   Height (377)   Height (in) (2)   Height in Inches (81)   HP (2)   Initial Accuracy (2)   Installation allowance (12)   Joules (8)   Length (49)   Length in Inches (3)   Load Rating (Volts) (4)   Location Area (In.) (4)   Mark II Slip Test Resul. (25)   Mat Thickness (4)   Maximum Lamination Thic. (1)   Measuring range mm/inch (2)   mL/cc per Minute Min (10)   mL/cc per Stroke Min (10)   Motor Output (HP) (1)   Net Weight (1)   Noise Reduction Coeffic. (1)   Oxygen Concentration Re. (5)   Part Status (4)   Pkg. Weight (lbs) (8)   PLC Input Voltage (2)   Product height (3)   Product length (25)   Product Weight (31)   Product Weight (lbs) (4)   Product width (7)   Range (11)   Rear Toe Degree of Corr. (1)   Rear Toe Degree of Corr. (1)   Repeatability (4)   Resolution (8)   Scale (27)   Seated Amps (1)   Shipping Height (5)   Size (6)   Thickness (12)   Thickness (In.) (2)   Tilt (Degrees) (2)   Tip Size (3)   Tolerance (14)   Tolerance (± ml) (24)   VOC Content (1)   Wall Thickness (6)   Weight (328)   Weight / LBS (13)   Weight Lb (23)   Width (155)   Width - Cable Tie (4)   Width in Inches (31)