Photoelectric sensor, retroreflective (reflector supplied), 200mm, DC, 3-wire, NPN, light-on, side-view, 2m cable (requires bracket)

[Sensing method] Retro-reflective without M.S.R. function <br>[Sensing distance] 10 mm to 200 mm (When using the E39-R4) <br>[Standard sensing object] Opaque 27 mm dia. Min. <br>[Min. sensing object] 2 mm dia. Min. <br>[Directional angle] Sensor:2 to 20 DEG,Reflector:2 to 20 DEG Min. <br>[Light source] Red LED (Emission wave length: 650nm) <br>[Power supply voltage] 12 to 24 VDC -10% to 10% (ripple(p-p) :10% Max.) <br>[Current consumption] 20mA DC Max. <br>[Control output] Output type: NPN open collector output <br>Load current: 0 to 50 mA <br>Residual voltage: (DC) 1 V Max. (Load current: Less than 10mA) <br>(DC) 2 V Max. (Load current: 10 to 50mA) <br>[Operation mode] Light-ON <br>[Load power supply voltage] 26.4 VDC Max. <br>[Protective circuit] Surge suppressor <br>Output short-cut protection <br>Output reverse polarity protection <br>Power supply reverse polarity protection <br>Mutual interference prevention <br>[Response time] 1ms Max. <br>[Dielectric strength] 1000 VAC at 50/60 Hz for 1 minute between charged parts and the case <br>[Degree of protection] IEC60529: IP67 <br>[Applicable standard (EC Directive (EMC))] EMI: EN60947-5-2 <br>Emission Enclosure: EN55011 Group 1 class A <br>EMS: EN60947-5-2 <br>Immunity ESD: IEC61000-4-2 <br>Immunity RF-interference: IEC61000-4-3 <br>Immunity Burst: IEC61000-4-4 <br>[Conformed standard (EC Directive (CE marking))] Equipped <br>[Connection method] Pre-wired models (Cable length: 2 m) <br>[Indicator] Operation indicator(orange), Stability indicator(green) <br>[Weight (packed state)] Approx. 20 g <br>[Tightening torque] 0.15 N.mMax. (with M2 screw via flat washers or spring washers) <br>[Accessories] Instruction manual, Set screws for mounting(M2*14), Nuts, Reflector(E39-R4)<br><br><br>(1)