Linear Support Rail, For Use With Thomson 60 Case Shafting and Linear Bearings, System of Measurement Inch

Technical Specification Item Linear Shaft Support Rail Type Low, Pre-Drilled Shaft Dia. 0.625 Mounting Hole from Shaft End 2 Mounting Hole Center to Center 4 Mounting Hole Size 0.193 Bolt Size #8-32 Length 24 Base Width (In.) 0.45 Material Steel For Use With Thomson 60Case shafting And Linear Bearings Compliance and Restrictions This item is restricted for international sale. This listing is for each. Dia. Tolerance Max. : - Mounting Surface to Shaft Center (In.) : - Dimension F : - Shaft Dia. : 0.625 in Item : Linear Shaft Support Rail Length : 24 in Temp. Range (F) : - Min. Surface Hardness : - Dimension M : - Dimension E : - Base Height (mm) : - Dimension L : - Base Width (mm) : - Agency Compliance : - Mounting Holes : - Mounting Hole from Shaft End : 2 in Thread Length (mm) : - Base Height (In.) : - Dimension G : - Finish : - Mounting End Dia. (mm) : - Dimension C : - Mounting Hole Center to Center : 4 Thread Size : - Mounting End Dia. (In.) : - Bolt Size : #8-32 Base Width (In.) : 0.45 in Dimension P : - Dia. Tolerance Min. : - Dimension X : - Material : Steel Includes : - Dimension Y : - Type : Low, Pre-Drilled Dimension B : 0.45 in Overall Height (In.) : - Mounting Hole Size : 0.193 Overall Height (mm) : - Thread Length (In.) : - For Use With : Thomson 60 Case Shafting and Linear Bearings Dimension N : Rail Length : Dimension W : Max. Speed (m/Sec) : Liner : Dimension S X l (Carriage Hole Size) : Running Clearance (In/mm) : Carriage Material : Static Load Capacity (Lb.) : Dimension H4 : Dimension W4 : Max. Speed (In/Sec) : Mounting Hole Center to Center (In/mm) : Dimension D2 : Dynamic Load Capacity (N) : Dimension L1 : Static Load Capacity (N) : Cnt Mtg Hole to Qualify Edge (In/mm) : Carriage Hole Size (In.) : Hole Size : Dimension L2 : Rail Material : Carriage Hole Size (mm) : Rail Width (mm) : Number of Rail Holes : Dynamic Load Capacity (Lb.) : Dimension W1 : Mounting Hole to End (In/mm) : Travel Length (In.) : Base Width : Carriage