Attributes . 9/16" . Names

Air Cylinder Bore Dia. (1)   Base Length Fraction (i. (9)   Base Width Fraction (in) (12)   Basis Weight (1)   Bit Dia. (3)   Bit Size (2)   Body Length (3)   Bolt Hole Size (6)   Bolt Protection (621)   Bolt Size (6)   Bore Dia. (1)   Bore Hole Size (1)   Bore Size (2)   Brush Thickness (2)   Channel Width (3)   Coil Voltage Rating (2)   Contact Configuration (8)   Contact Size (185)   Cutting Diameter (1)   Cutting Length (2)   Depth (3)   Depth of Cut (1)   Diameter (53)   Diameter (D) (1)   Diameter 2 (3)   diameter fractional (1)   Dimension (in.) (E) (2)   Dimension D (7)   Dimensions C (2)   Drill Bit Size (8)   Drill diameter (1)   Drill Size Fraction (in) (1)   End - Size (2)   End 1 Thread (2)   Estimated Weight (1)   F (4)   Fastener Length (4)   Female Thread Length (2)   Fits Bolt Size (2)   Fits Bolt Sizes (2)   Fitting Length (2)   Flute Length (5)   For Glass Size (1)   For Screw Size (2)   Fractional Size: (7)   Front Face Width (Inche. (1)   Grip Length (1)   Groove Diameter (1)   H1 Stem Hex (in) (1)   Head Dia. (3)   Head Diameter (22)   Head Length (2)   Head Thickness (3)   Head Width (38)   Height (31)   Height [in]: (4)   Hex (41)   Hex Size (14)   Holding Diameter (1)   Hole Size: (6)   Hose Clamp Band Width (9)   Hose Fitting A Size (3)   Hose Fitting B Size (1)   Hose OD From (10)   Hose Outside Dia. (1)   Hose Outside Dia. (In.) (3)   Housing Width (1)   Id (2)   Inner Diameter - Fracti. (1)   Inside Dia. (2)   Inside Dia. (In.) (2)   Jaw Opening (1)   Keeper Width (1)   Leg Length (14)   Length (7)   Length of Cut (13)   LOC (Fractional) (17)   Manufacturer Item Number (1)   Mat Thickness (4)   Maximum Cutting Capacit. (2)   Milling Dia. (3)   Milling Diameter (5)   Min. Clamp Dia. (2)   Minimum Bore (6)   Minimum Bore Diameter (4)   Minimum Clamp Diameter (1)   Mounting Hole Diameter . (11)   Neck Length (1)   Nominal Outside Dia. (1)   Nominal Size (2)   Nominal Size (In.) (2)   Nut Height (1)   O.D. (6)   OD (Fractional) (17)   Oil hole center (1)   Oil Hole Location (1)   Open End Thickness (2)   Open End Width (Inches) (2)   Outer Diameter - Fracti. (2)   Output Size: (2)