Attributes . ?20% . Names

Shipping Depth (3)   Shipping Width (1)   Shipping Width (In.) (5)   ShipWidth (1)   SHK (Fractional) (14)   SHK (Metric) (17)   Short Circuit Current (1)   Shoulder Length (6)   Side Table Height (1)   Single Sheet Speed (Ft.. (1)   Sink Back To Front Dime. (1)   Sink Drain Distance Fro. (1)   Sink Length Left to Rig. (2)   Sink Width Front to Back (2)   Size (126)   Size (Height) (3)   Size (In.) (1)   Size (Outside Diameter) (7)   Size / Dimension (1)   Sizes Included (2)   Smallest Shelf Size (2)   Socket Piece Count (1)   Sockets (2)   Sold As (3)   Sold in Multiples of (5)   Solids Content (1)   Sones @ 0.250-In. SP @ . (1)   Span (1)   Speed, Seconds/90° (2)   Spring (psi) (1)   Spring force final pres. (3)   Spring force initial pr. (2)   Square Feet (3)   Square Footage (1)   Stack Capacity (1)   Stage 1: Dual cam engin. (2)   Standard Lift (feet) (2)   Standard Pack: (7)   Standard Package (103)   Stroke Length (Adjustab. (102)   Stroke mm (4)   Stud Dia. (mm) (4)   Style (9)   Sub Divisions ml (28)   Substrate Outside Diame. (1)   Supp Curr. I(TSM) (10)   SUPPORT CENTERS (1)   Sw. Volt P-P Max.(V) (90)   Swing (2)   T (10)   t(switch) Off Typ. Time. (1)   Table Length (2)   Table Width (2)   Tank Size (gal.) (1)   Tap Quantity (3)   Taper (1)   Teeth (5)   Teeth per Inch (2)   Temp Coef pp/10k (1)   Temp Coefficient (ppm/C) (5)   Temp Drift (ppm/?C) (2)   Temp Drift Max. (ppm/?C) (11)   Temperature Coefficient (1)   Temperature Rating (3)   Tensile Elongation at B. (9)   Tensile Strength (3)   Term Dash Size (3)   Test Condition (1)   Test Current (1)   THD (1)   Thickness (mm) (2)   Thickness T(mm) (2)   Thread (1)   Thread 1 Nominal Size (10)   Thread 2 Nominal Size (12)   Thread 3 Nominal Size (2)   Thread diameter - milli. (1)   Thread diameter size (T. (1)   Thread Pitch (1)   Threads per Inch (29)   Threads per Inch (TPI) (3)   Tightening Torque (Reco. (1)   Tilt Angle (deg) (2)   Time Tolerance: (3)   Timing Range (3)   Tip Size (1)   Tire Size 1 (3)   Tol. (%) (71)   Tolerance (12496)   Tolerance Minus (37)   Tolerance Percentage (2)   Tolerance Plus (34)   Tolerance Resistance (2)   Tool Size (1)   Tooth pitch (2)   Toothcount (1)   Top Diameter (1)   Top Step Height (2)   Top Step Height (in.) (1)   Torque Rating (4)