Attributes . ?20% . Names

Spring force final pres. (3)   Spring force initial pr. (22)   Square Feet (5)   Square Footage (1)   square size mm (1)   Stack Capacity (3)   Stage 1: Dual cam engin. (2)   Stand Width (In.) (4)   Standard Bar Length (1)   Standard Extrusion Size. (4)   Standard kVA (1)   Standard Lift (feet) (2)   Standard Pack: (263)   Standard Package (280)   Standard Package Quanti. (1)   Standard Pressure Close. (5)   Starting Temperature - . (1)   Static Load Capacity (L. (2)   Std. Pkg. Qty. (2)   Stool Length (1)   Stroke (3)   Stroke (in) (3)   Stroke (mm) (4)   Stroke Length (9)   Stroke Length (Adjustab. (280)   Stroke Length (in.) (1)   Stud Dia. (mm) (4)   Style (30)   Sub Divisions ml (76)   Substrate Outside Diame. (1)   Supp Curr. I(TSM) (39)   Supplier Device Package (9)   SUPPORT CENTERS (1)   SW (1)   Sw. Volt P-P Max.(V) (226)   Swing (2)   Swing In Gap (In.) (5)   Swing Over Bed (1)   Swing Over Bed (In.) (6)   Swing Through Gap (In.) (8)   T (10)   t(switch) Off Typ. Time. (75)   Table Length (4)   Table Top Width (1)   Table Width (4)   Tank Size (gal.) (1)   Tank Width (In.) (1)   Tap Quantity (3)   Tape Elongation (1)   Taper (1)   Taper Angle (2)   Taper Angle per Side (1)   Teeth (60)   Teeth per Inch (19)   Temp Coef pp/10k (19)   Temp Coefficient (ppm/C) (48)   Temp Drift (ppm/?C) (16)   Temp Drift Max. (ppm/?C) (21)   Temperature Coefficient (1)   Temperature Range (3)   Temperature Rating (14)   Tensile Elongation at B. (28)   Tensile Strength (3)   Tensile Strength (PSI) (9)   Term Dash Size (3)   Terminal Angle (1)   Terminal Block Min Wire. (7)   Termination Finish Thic. (3)   Termination Style (2)   Test Condition (6)   Test Current (4)   THD (9)   Thickness (9)   Thickness T(mm) (6)   Thickness(?m) (1)   Thickness(mm) (4)   Thread (1)   Thread 1 Nominal Size (20)   Thread 2 Nominal Size (16)   Thread 3 Nominal Size (2)   Thread diameter - milli. (3)   Thread diameter size (T. (4)   Thread Length (mm) (8)   Thread Pitch (148)   Thread Size (10)   Threads per Inch (109)   Threads per inch (TPI) (5)   Threshold Height (in) (4)   Throat Capacity (1)   Throat Dia. (In.) (1)   Tightening Torque (Reco. (1)   Tilt Angle (deg) (3)   Time Tolerance: (5)   Timing Range: (4)   Tip Size (8)   Tire Size 1 (3)   Tol. (%) (105)   Tolerance (38183)   Tolerance for nominal t. (11)   Tolerance Minus (94)