Attributes . 1-3/8 . Names

Max. Installation Surfa. (5)   Max. Jaw Opening (2)   Max. Tap Capacity (8)   Maximum Carbide Cutting. (1)   Maximum Length of Cut (4)   Maximum Material Thickn. (9)   Maximum O.D. (6)   Measurements (8)   Milling Diameter (3)   Min. Full Thread Depth (3)   Min. Thread Length (25)   Minimum Cabinet Opening. (3)   Minimum Door Thickness (7)   Minimum Expanding Stem . (1)   Minimum Thread Length (3)   MOD In Inches (3)   MOL In Inches (1)   Neck Diameter (1)   Nominal Inside Dia. (8)   Nominal Outside Dia. (6)   Nominal Rail Size (In.) (1)   nominal shaft diameter: (1)   Nominal size? (4)   Nut Depth [in] (4)   O.D. (1)   O.D. (in) (7)   OD (5)   od in (1)   Open End Width (5)   Outer Diameter (1)   Outer Diameter - Fracti. (1)   Output Shaft Dia. (11)   Output Size (2)   Outside Dia. (39)   Outside Diameter (3)   Outside Dimension (1)   Outside Height (13)   Outside Width (5)   Outter Diameter (2)   Overall Height (3)   Overall Length (40)   Overall Length (In.) (11)   Overall length - fracti. (2)   Overall Width (414)   Overlay (2)   Pin Center to Tang End (1)   Pin Dia. (3)   Pin Diameter (1)   Pin Hole: (3)   Plate Width (2)   Pleat Size (1)   Point Size (2)   Port Size (2)   Product Clearance (2)   Product length (2)   Product Projection Frac. (34)   Projection (94)   Projection Size (7)   Reamer Size (4)   Receptacle Connector Ty. (20)   Required Door Thickness (10)   Required door thickness. (1)   Required Hole Size (16)   Rim Measurement (6)   Ring Diameter (1)   Rod Dia. (5)   Rod Dia. (In.) (4)   Roller Width (1)   Saw Dia. (5)   Shackle Clearance (7)   Shaft Dia. (32)   Shaft Dia. (Dimension U) (1)   Shaft Diameter (86)   Shaft Diameter (in) (1)   Shaft Length (3)   Shaft Size (4)   Shank Length (6)   Shank Size (5)   Short Arm Length (1)   Shoulder Length (3)   Shrink Ratio (1)   Side 1 Connector (97)   Side 2 Connector (63)   Size Range (2)   Size(in) (2)   Size: (62)   Sizes Included (2)   Slide Track Depth (Inch. (5)   Socket Size (1)   Socket Sizes (3)   Space Between Studs (1)   Spindle Bore (In.) (24)   Spindle Dia. (2)   Spout Height (3)   Spout Hole (16)   Stem Dia. (35)   Stem Length (4)   Suction Line Size (OD) (6)   Suction Tube Outlet O.D. (4)   Tap Size (2)